Name: OH2 Type Centerline Mounted End Suction Process Pump
Brand: LUBOR PUMP
Availability: InStock

Specification and Performance of API 610 OH2 Type Centerline Mounted Pump

Standard	API610 OH2/DIN/ISO/VDMA 24297
Casing	Radial Casing
Stage	Single
Capacity	Up to 2600 m³/h / 11450 US gpm
Head	Up to 250m / 820ft
Frequency	50/60Hz
Temperature	Up to 450℃/900℉
Discharge size	32 to 700 mm / 1 ¼ to 28 inches
Pressure	Up to 50 bar / 720 psi
Drive	Motor/ gear

Accessories support

Motor	ABB/Siemens/WEG
Coupling	TRUMY
Mechanical seal	John Crane
Flushing system	Colossus
Bearing	SKF/FAG
Electric	ABB/Siemens/DELIXI

Why Centerline Mounting Matters in Hot Service

A centerline mounted pump supports the casing near its horizontal centerline so thermal growth can occur more evenly above and below the support plane. For hot process service, this arrangement helps reduce the alignment change that can occur when a foot-mounted casing expands from its base.

When specifying an API 610 OH2 pump, review the operating temperature range, piping loads, baseplate and grout condition, cold-to-hot alignment procedure, coupling selection and seal support system. Centerline mounting does not remove the need for correct piping and alignment; it provides a more suitable mechanical arrangement for temperature-sensitive process duty.

If the required duty needs a between-bearings arrangement or higher structural stability, compare the OH2 configuration with an API 610 BB2 design using the same process datasheet.

Industries Served by API 610 OH2 Type Centerline Mounted Pump

APPLICATION

Booster pumps for medium-sized boiler feed water units in conventional thermal and combined cycle power stations
Hot water circulation pumps in district heating plants and boiler circulation in industrial power generation
Auxiliary pumps in conventional and renewable thermal power stations
Main and auxiliary Heat Transfer Fluid (HTF) circulation in solar power stations
Feed pumps, second pass pumps, and Energy Recovery Device (ERD) circulation pumps in desalination by reverse osmosis

Application Examples

Ethylene Unit

Ethylene is one of the basic raw materials for petrochemicals. The ethylene unit is the most important unit for petrochemicals. Many synthetic materials can be produced from ethylene and related products, which can be used in many industries. The ethylene capacity, a mark of petrochemical industries and economic development, is also guaranteed by the efficient operation of key equipment including api 610 vs6, as well as api oh2 and oh2 type pump